Skip to content
Browse guides

Metrics explained

FTP (functional threshold power): what it is and how to test it

FTP is the highest power you can sustain for about an hour. It is the anchor for cycling training zones, training stress scores and pacing.

4 min readUpdated November 2, 2026

Written by

Community-authored educational content. Individual clinical review is identified only when a named review is actually recorded.

Editorial standards & corrections
FTP (functional threshold power): what it is and how to test it: FTP is the highest power you can sustain for about an hour. It is the anchor for cycling training zones, training stress scores and pacing.

Key takeaways

  • A 20-minute test estimates FTP as 95 % of average power, and a ramp test as about 75 % of best 1-minute power, which overestimates FTP for riders with strong anaerobic capacity.
  • Recreational riders typically reach 2.5–3.2 W/kg for men and 2.2–2.8 W/kg for women, and strong amateurs 3.5–4.2 and 3.0–3.7.
  • Raise FTP with sweet spot at 88–94 % of FTP and threshold intervals such as 2 × 20 minutes, on top of plenty of zone 2 volume.
  • Indoor FTP is often 5–10 % lower than outdoors because of heat and fixed position, and retesting every 6–8 weeks keeps zones current.

Functional threshold power (FTP) is the highest average power, in watts, that a cyclist can hold for roughly 45–70 minutes in a fresh, motivated state. It sits close to your lactate threshold. Zwift, Wahoo, Garmin, COROS and smart trainers such as the Magene T600 all use FTP to set workout targets.

Testing protocols

TestProtocolFTP estimate
20-minute testWarm-up, 5 min hard, recovery, 20 min all-out95 % of 20-min average power
Ramp testPower rises every minute until failure~75 % of best 1-minute power
8-minute testTwo 8-min efforts90 % of the better average
60-minute effortTime trial or raceAverage power

The ramp test is short and popular on Zwift, but it overestimates FTP for riders with a strong anaerobic capacity and underestimates it for diesel-type riders. Pick one protocol and repeat it under similar conditions.

Typical values (W/kg)

LevelMenWomen
Untrained2.0–2.51.7–2.2
Recreational2.5–3.22.2–2.8
Strong amateur3.5–4.23.0–3.7
Elite amateur4.3–5.03.8–4.5
World Tour pro5.5–6.54.8–5.5

See power-to-weight ratio.

Power zones (Coggan)

Power zones are bands of effort set as a percentage of your FTP, so they move whenever your FTP changes. In the common seven-zone Coggan model, zone 2 (endurance) is about 56–75 % of FTP and zone 4 (threshold) about 91–105 %. See cycling power zones for the full table, what each zone feels like and a session to train it.

How to raise FTP

  • Sweet spot (88–94 % FTP) and threshold intervals such as 2 × 20 min or 3 × 15 min — see threshold and sweet spot.
  • Plenty of zone 2 volume.
  • VO2 max intervals to lift the ceiling.
  • Re-test every 6–8 weeks.

In MoveVitals

Power data from Zwift, Wahoo, Garmin and Magene (via Strava) is stored with full streams, so average and normalised power are available for every ride, and the original recording device is preserved.

Worked example

Worked example. After a proper warm-up, Ben rides an all-out but evenly paced 20-minute effort and averages 265 W. Using the common 95% rule, his estimated FTP is 265 × 0.95 ≈ 252 W. At 72 kg that is about 3.5 W/kg. His Coggan-style zones follow: Zone 2 (56–75%) ≈ 141–189 W, threshold (91–105%) ≈ 229–265 W. After an 8-week block with 2 × 20-minute sweet-spot sessions per week he retests at 271 W → FTP ≈ 257 W. The 95% factor is an estimate and individual ratios vary.

Cyclist holding steady threshold power on a climb with a power meter

Action steps

  1. Rest well the day before; test at the same time of day and setup as last time.
  2. Warm up 15–20 minutes, including a few short efforts.
  3. Pace the 20-minute effort evenly — start slightly conservative.
  4. Multiply by 0.95 (or use a ramp test's own formula) and update your zones.
  5. Retest every 6–8 weeks or when sessions feel consistently too easy or hard.

FAQ

Indoor FTP is lower than outdoors — normal? Yes, often by 5–10 % because of heat and fixed position. Use separate values if needed.

Is FTP the same as a 1-hour power? Close, but most people can hold FTP for 40–70 minutes.

Is a ramp test as good as a 20-minute test? Ramp tests are shorter and easier to repeat, but riders with strong anaerobic capacity often get an inflated FTP from them; stick to one protocol for comparisons.

How does FTP relate to lactate threshold? They are related but not identical; FTP is a performance estimate, while lactate threshold is measured from blood samples.

References

  1. Faude et al. (2009). Lactate Threshold Concepts. Sports Medicine. https://doi.org/10.2165/00007256-200939060-00003
  2. Seiler (2010). What is Best Practice for Training Intensity and Duration Distribution in Endurance Athletes?. International Journal of Sports Physiology and Performance. https://doi.org/10.1123/ijspp.5.3.276
  3. Rønnestad et al. (2014). Optimizing strength training for running and cycling endurance performance: A review. Scandinavian Journal of Medicine & Science in Sports. https://doi.org/10.1111/sms.12104

For general information only. This is not medical advice — talk to a qualified professional about your health.